RPT-C300 Battery Regenerator

 6V 12V Regenerator Mode(Max. 25A), Charge Mode, Power Supply Mode, Discharge Mode(Max. 30A) and Internal Resistance & CCA (For Car battery ) Checking (6-in-1) as newly upgraded. For 6V 12V all kinds of Lead-Acid Batteries, the regeneration performance will be much superior to any other products. Input AC Power Consumption: 550W (max.). You can resell RPT-C300 to Battery wholesale, retail shops and Car repair shops as a battery physician. This item will be very good for battery sellers due to the superior restoration effectiveness for feeble new batteries which lost chemical activation and over-discharged.  All functions and features are same with RPT-T300 (7-in-1).  Only one difference is RPT-C300 (6-in-1) does not have the 'Condition Test' mode. (Same as a Battery Condition Identifier) 280mm(H) x 430mm(W) x 520mm(D), 13.2kg

1. Battery Regenerator at REGENERATION mode

2. Battery Charger at 'CHARGE' mode

3. Power Supply at 'POWER SUPPLY' mode (Manual setting mode of Voltage, Current & Time for special & sleeping batteries)

4. Battery Discharger (420 Watts) at 'DISCHARGE' mode

5. IR (Internal Resistance) Checking - before & after 2 ways

6. CCA (Clod Cranking Ampere for Car Battery ONLY) Checking - before & after 2 ways

* Maximum Limited Output Current : 6V 12V = 25A

* A serial connection up to 6V x 2 or 2V x 6 (12V) batteries at the same time. (up to 300Ah).

* SPECIAL FEATURES:

1) The most advanced battery regenerator  Highest restoration performance (Regenerator Mode)

2) The highest efficient battery charger (Charge Mode)

3) Perfect desulfation performance by high-frequency pulse and charge algorithm

4) Special Battery Regenerative Power Supply (Power Supply Mode)

5) Lower Current Charging for Non-used battery (Sleeping Battery) for a long time (Power Supply Mode)

6) Stable Digital Discharger (Discharge Mode ; Max. 30A)

7) Measurements for Voltage, Internal Resistance and CCA (Car battery ONLY)

8) A full automation and easy to use

9) Monitoring graph for output Voltage & Current situation in real time - Can be communicated with a Computer connecting by the USB Serial Port. USB Drive should be installed for the USB Serial Port, before connecting with the regenerator and computer. When you press this 'PRINT' Button, the graph will be printed on the above sheet image. ('USB AM-AM Cable with double-shielded' will be included in a package)